The difference??
| Solution | Kit | Pinion | Main | Ratio | Axis D | |
| 1 | Basic Gasserman conversion | T-REX 700Gasser from Gasserman o.n: AE000400 | Pinion T27 Modul 0,7 o.n:AE000404 | Originall Align injected white plastic T164 Module 0,7 o.n: HN7019T | 6,07 |
67.5 (66.9) |
| 2 | Tuning Gasserman conversion main gear only | T-REX 700Gasser from Gasserman o.n: AE000400 | Pinion T27 Modul 0,7 o.n:AE000404 | Black Derlin T164 Module 0,7 AE000410 | 6,07 | 67.5 |
| 3 | Tuning Gasserman to Module1 complete | T-Rex 700Gasser from Gaserman
o.n: AE000400 |
Pinion T19 Module o.n | Black Derlin T115 Module 1 | 6.07 | 67.5 |
| 4 | T-REX 700Nitro OS engine | T-REX T700Nitro from Align | Pinion T14 Module1 o.n: | Black Derlin T115 Module 1 o.n:AE000411 | 8.21 | 65.0 (64,5) |
| 5 | T-REX 700Nitro YS engine | T-REX T700Nitro from Align | Pinion T15 Module1 o.n: | Black Derlin T114 Module 1 | 7.6 | 65.0 |
Glow helis: ratio
8.21 original with modul 0.7 is piniomn 20 and 164T main axis distance
65
and my set is ratio 8.21 modul 1.0 is pinion 14T main is 115T
axis distance 65 - so you dont need mowe bearing house on glow!
Gasser helis ratio 6,07 at originall
gasserman conversions modul 0,7 pinion T27 main T164 axis distance 67.0
and my new set tartio 6,07 at originall gasserman conversions
but modul 1 pinion T 19 main gear 115T (same as glow) distance 67.0 mm!
Conclusion: Glow and at Gassers you don't
need to change anything, just swop the gearing set and go fly!
IMPORTANT! How to align the gear mesh.
| lose 6 bolts on each side frame that go into the clutch and main shaft bearing blocks | |
| then cut a strip of regular paper and thread it through the pinion/main gear until it sticks out both sides. | |
| then loctite and tighten all the bearing block bolts and remove the paper. The gear mesh will be right | |
| Dont forget to go fly :D |
The difference??
Videos how the wheels made: herehere and here
 |
 |
||
 |
 |
||
 |
 |
||
 |
 |
||
 |