First step: Mount the front  engine/clutch support
 Next step page2 Use 4 metric bolts M5x10 mm. The plate is made to fit EXACTLY the hole diameter to ensure there is no gap around the holder. You have to use a bit of force to slide the support plate at the neck to the front of engine. If you have difficulties in fitting the engine mount properly, use sand paper to adjust the fit.
Attention!
1) Don't use washers. The holder’s job is to keep the engine aligned to the clutch and stop the twisting forces when the engine accelerates. There are no axial forces to the plate. Don't forget to use red loctite. Tighten the bolts well and check this step twice. You won't have another chance to check the bolts are tight after the fan shroud is fitted.
2) Do not use other types of bolts other than hexagonal shown in the picture. They may have too high a head and will not allow you to mount the fan properly. Check the gap after the support is mounted by fitting the fan to the engine. The minimum clearance of 2 mm has to be there for a successful fit. ..