Buy it here http://gasserman.com/
PRICE USD 29  Connect red cable to kill

switch cable

You can use the Y leed

cable and still use same

connection to install kill

Switch
  Connect the Gasser Gator

cable to GV sensor plug. But

look on the picture!

The sensor cable have the

signal upward!
 
http://gassergator.com/videos.html Look vido page what you have to see after start up the motor  Theory of GV1 The lowest rotor RPM is 1000 
The GRt is from 3,00/1 ->
15,0/1
We have GRt 6,07/1 than it
start by 6070rpm at engine Use pin to move the functions around the menu to find out
the GRT  Move by +- and set the proper
ratting 164/27=6.07 Speed funcions RPM - Speed display 
MAX Speed monitor 
MAX speed checker  rSX speed settings If  NOT used cable for speed setting cable use S2 set speed to
10 000 get 1650 RPM on rotor  Governor OFF ON functions SWichPT ON/OFF  Set  OFF StSWitch stick ON operation Keep off it will start at min RPM or set ON it will start at pre-set position SWCd  ON/OFF confirmation of actual situation Gov OFF High oFF stick position
keep OFF Battery voltage  Volt  Show RX voltage Mixture functions MXMD
MD
ATV
MSx
MTrm keep all default Battery fail save  B/FS
B/FD OFF Operating rates Lmt
TST set limits here
Test limits here Sen  Sensor position check Can't be seen at GGator

  If Stick SW is OFF than governor start work
at MAX SLOW position !!
  Engine  Rotor 6070 1000 7300 1200 8500 1400 10 000 1650 11 000 1800 12 100 2000